User guide

Viz Engine Administrator’s Guide

Once the machine is powered up you may verify that the Matrox X.mio board has been

correctly installed by looking for the blue OB -light on the (top) backside of the slot

panel. A lit light indicates that the board is correctly supplied with power.

To setup an HP DL370 G6 with a capture card

PCI and PCIe slots, HP DL370 G6

IMPORTANT! Before touching any components make sure you use an anti-static

wrist strap to prevent electrostatic discharge.

1. Disconnect the power and all other peripherals.

2. Insert the graphics card in PCIe2 slot number 8 from the left.

3. Insert the capture card in PCIe2 slot number 6 from the left.

4. Insert the SDI output board in the PCIe2 slot number 4 from the left.

5. Tidy up all cables and close the computer’s casing.

To configure the BIOS

1. Start the machine and open the machine’s BIOS system

2. Go to System Options > Processor Options

3. Deactivate Hyperthreading

• The Matrox X.mio2 board will not function if this setting is enabled

4. Deactivate Intel Virtualization Technology

5. Deactivate Intel VT-d2

Note: Steps 2 and 3 are only needed for VMWare setups

6. Go to Power Management Options > Advanced Power Management

Options > PCI Express Generation 2.0 Support

7. Activate Force PCI-E Generation 2