User guide

Viz Engine Administrator’s Guide

12. Open the NVIDIA Control Panel, and click on System Information in the bottom left

corner and check that both graphics cards are installed and run at PCIe x16 speed.

13. Open Matrox X.info from the system tray and check that the video board runs at

PCIe x8 speed.

Once the machine is powered up you may verify that the Matrox X.mio board has been

correctly installed by looking for the blue OB -light on the (top) backside of the slot

panel. A lit light indicates that the board is correctly supplied with power.

To setup an HP Z800 with a capture card

PCI and PCIe slots, HP Z800

IMPORTANT! Before touching any components make sure you use an anti-static

wrist strap to prevent electrostatic discharge.

1. Disconnect the power and all other peripherals.

2. Insert the graphics card in PCIe2 slot number 2 from the top.

3. Insert the NVIDIA capture card into the PCIe2 slot number 4 from the top.

4. Tidy up all cables and close the computer’s casing.

20.5 HP DL370 Installations

This section describes how to setup a HP DL370 G6 machine with the different cards

provided by Vizrt:

• To setup an HP DL370 G6 with one graphics card

• To setup an HP DL370 G6 with two graphics cards

• To setup an HP DL370 G6 with a capture card

• To configure the BIOS