User guide

Viz Engine Administrator’s Guide

To setup an HP Z800 with a DVS board

PCI-X , PCI and AGP slots, HP Z800

IMPORTANT! Before touching any components make sure you use an anti-static

wrist strap to prevent electrostatic discharge.

1. Disconnect the power and all other peripherals.

2. Install the video board in slot number 5 from the top.

3. Install the graphics card in slot number 2 from the top.

4. Install the separate SDI/RS-422 panel in slot number 1 from the top.

• Make sure that the cable connections are properly mounted and that it stays

clear of any supplemental aerators or the aerator of the graphics device.

5. Tidy up all cables and close the computer’s casing.

Note: Placement of cards are the same for both Digital Video Systems and DVS

Centaurus II

To setup an HP Z800 with a Matrox board

PCI and PCIe slots, HP Z800

IMPORTANT! Before touching any components make sure you use an anti-static

wrist strap to prevent electrostatic discharge.

1. Disconnect the power and all other peripherals.

2. Insert the graphics card in PCIe2 slot number 2 from the top.

3. Insert the Matrox video board into the PCIe2 slot number 5 from the top.