User guide

Viz Engine Administrator’s Guide

IMPORTANT! Before touching any components make sure you use an anti-static

wrist strap to prevent electrostatic discharge.

1. Disconnect the power and all other peripherals.

2. Insert the graphics card in slot 20.

3. Insert the NVIDIA capture card in slot 22.

4. Tidy up all cables and close the computer’s casing.

20.3 HP Z820 Installations

This section describes how to setup a HP Z820 machine with the different cards

provided by Vizrt:

• To setup an HP Z820 with a Matrox board

• To setup an HP Z820 with two graphics cards

See Also

• NVIDIA Graphics Cards

• Digital Video Systems

• Matrox X.mio Series

• Matrox DSX LE Series

• NVIDIA Quadro SDI Capture

To setup an HP Z820 with a Matrox board

PCI and PCIe slots, HP Z820

IMPORTANT! Before touching any components make sure you use an anti-static

wrist strap to prevent electrostatic discharge.

1. Disconnect the power and all other peripherals.

2. Insert the graphics card in slot 17.

3. Insert the Matrox video board in slot 21.

4. Insert the radial-aerator in slot 22.

IMPORTANT! The Matrox video boards can reach very high temperatures

when in operation. If a Xmio.2 board is used, a radial-aerator must be

installed. If a Xmio.2 Plus board is used a radial-aerator can not, phiscally,