User guide

Viz Engine Administrator’s Guide

PCI-X , PCI and AGP slots, HP Z420

IMPORTANT! Before touching any components make sure you use an anti-static

wrist strap to prevent electrostatic discharge.

1. Disconnect the power and all other peripherals.

2. Insert the graphics card in slot 20.

3. Insert the BlueFish444 video board in slot 22.

Note: If you are using the BNC adaptor with the Epoch|2K Horizon board it

can be placed directly adjacent the video board on either side.

4. Tidy up all cables and close the computer’s casing.

To setup an HP Z420 with a DVS board

PCI-X , PCI and AGP slots, HP Z420

IMPORTANT! Before touching any components make sure you use an anti-static

wrist strap to prevent electrostatic discharge.

1. Disconnect the power and all other peripherals.

2. Install the video board in slot 22.

3. Install the graphics card in slot 20.

4. Install the video board two extension boards:

• SDI/RS-422 panel in slot 19

• BNC panel in slot 23

Note: Make sure that the cable connections are correctly mounted and that

they stay clear of any supplemental aerators or the aerator of the graphics

device.

5. Tidy up all cables and close the computer’s casing.