User guide

Viz Engine Administrator’s Guide

2. The slot panel has numbers from 1-4 as well as the X.RIO board, just connect

them carefully, because the mini BNC’s are easily broken.

3. Mount the X.RIO on the X.mio2 board “Mod A” connector. The Mod B connector

will not work.

4. Use the screws to fix the X.RIO board.

5. When building the X.mio2 with X.RIO into the Z800 be careful that the mini BNC’s

do not get disconnected as they are very hard to connect while the X.RIO board is

mounted on the X.mio2.

6. Mount the slot panel with the 4 additional inputs in any free slot and connect the

power for the X.RIO. Also, make sure the cables do not touch any fans.

To Configure the Matrox X.RIO Board

1. Install Matrox driver version 7.5.2.1448

2. Start Matrox X.Info

3. Under the X.mio2 /24 Card tab select the Hardware option

• This should enable the X.RIO Configure button

4. In the X.RIO Module Configuration dialog-box check that the configuration for next

restart is set to 4 Inputs 0 Outputs

5. Restart your computer