User guide

Viz Engine Administrator’s Guide

For this a reset mechanism has been implemented for the Viz Engine. To activate this

mechanism please execute the following steps:

1. Stop all Viz Engines (in dual channel setups both Viz Engines must be stopped)

2. Open the config file and set Matrox0.ResetTopology = 1

3. Start up the respective Viz Engines

• The Matrox0.ResetTopology setting will be automatically set back to 0 after

the reset was done.

The reset feature also clears the on-board memory of the X.mio2 Plus board. This

operation removes all Watchdogs and their topologies from the on-board memory.

After the reset everything will be restored automatically according to the configuration

settings (this applies to both Viz Engines in a dual channel setup).