User guide

Viz Engine Administrator’s Guide
Page 264 Copyright © 2014 Vizrt
15.1.1 Breakout Cables and Connectors
Both the DSX.LE3 and DSX.LE2/CG come with a set of breakout and power cables (no
break-out box required).
The power cables must be connected or else the board will not work.
The breakout cable is used for the reference signal ( GenLock ) and AES output. Fill
and key signals have their own BNC connectors. Both boards should be installed in
the same slot as the X.mio2/2Plus board. Note that the DSX boards only supports
embedded audio, hence, there are no audio-extension cards for AES input.
15.1.2 Video Cable Assignment
Matrox DSX.LE3 and DSX.LE2/CG are both HD ready. The DSX.LE3 has 4 video output
connectors, whereas the DSX.LE2/CG has 2 video output connectors. None of them
have video input capabilities. The boards are used for outputting fill and key signals,
and are useful in systems that do not need live video input or codec support.
The 4 video output connectors for the DSX.LE3 will give you two pairs of fill and key,
where output A and B are Fill and output C and D are Key, respectively.
The 2 video output connectors for the DSX.LE2/CG 2 will give you one pair of fill and
key, where output A is Fill and output B is Key.
15.1.3 Audio Cable Assignment
This section contains information on the following topics:
• AES input cable assignment
• AES output cable assignment
• Embedded input
• Embedded output
AES input cable assignment
Card Viz audio
config
AES Cable Matrox Video
Channel
DSX.LE3
DSX.LE2/CG
2 tracks Not supported
4 tracks Not supported
8 tracks Not supported
16 tracks Not supported
AES output cable assignment
Card Viz audio
config
AES Cable Matrox Video
Channel
DSX.LE3 2 tracks A OUT 1/2 Audio OUT 0