User guide

Viz Engine Administrator’s Guide

• To install the Matrox driver

• To remove the Matrox driver

• To verify the installation using Matrox X.info

• To verify the installation using Windows Device Manager

To install the Matrox driver

1. Start the machine.

2. Cancel any Found New Hardware Wizard dialog boxes.

3. Locate the Mio Tools setup executable (setup.exe), and start the installation.

4. In the Matrox Firmware Updater dialog box, select the Onboard compositor

firmware option, and click OK.

• The firmware upgrade may take several minutes.

Note: X.mio, not X.mio2/2 Plus

5. Once the upgrade is complete, click OK to close the Setup dialog box and to

restart the system.

• After the restart the firmware settings will take effect and the setup will

continue.

6. Cancel any Found New Hardware Wizard dialog boxes.

7. In the Welcome to Matrox Setup dialog box, click Next to continue the setup.

8. Click Yes to acknowledge the license agreement.

9. In the Select Program Folder dialog box, click Next or select another program

folder and click Next.

10. In the Choose Destination Folder dialog box, click Next or select a different

destination folder.

• The installation of driver files may take several minutes.

11. Once the installation is complete, click OK to close the Install Complete dialog box

and to restart the system.

To remove the Matrox driver

Removing video board drivers, Device Manager

1. Open the Device Manager (see also To verify the installation using Windows

Device Manager )