Installation manual

Appendices Nucoda and Phoenix 2014 Install Manual
Internet Protocol (TCP/IPv4)
● In the new dialog that opens, make sure you select :
Use the following IP address
Set the IP address and Subnet mask to the desired values e.g.
Replace the above settings with those you require (as directed).
note
A network port attached to a control panel requires only the IP address and the
Subnet mask set.
● Press OK until we exit all the dialogs and then exit the Control Center.
Control Panel Specific Settings
If you are setting up the network port attached to a control panel, you should also
disable any TCP/IP checksum offload feature. This setting is found in the Adapter dialog
via the Configure... button.
● Open the Control Panel (Start / Control Panel)
● Select : Network and Sharing Center
● On the left-hand side, choose : Change adapter settings
IM-2014_1-1.0 Page 76