Installation manual

Appendices Nucoda and Phoenix 2014 Install Manual
● In the dialog that opens, double-click the item :
Internet Protocol Version 4 (TCP/IPv4)
● In the new dialog that opens, make sure you select :
Use the following IP address
Set the IP address and Subnet mask to the desired values e.g.
Replace the above example settings with those you require (as directed).
note
A network port attached to a control panel requires only the IP address and the
Subnet mask set.
● Press OK until we exit all the dialogs and then exit the Control Center.
Windows XP
● Open the Control Panel (Start / Control Panel)
● Double-click Network Connections
● In the list of adapters shown, double-click the one you want to change
● Click the Properties button
● In the dialog that opens, double-click the item :
IM-2014_1-1.0 Page 75