Installation manual

Telecine Control Nucoda and Phoenix 2014 Install Manual
e.g.
ifconfig vrr1 192.168.80.55 netmask 0xffffff00
● Save the file and reboot the unit.
● Test you can access the device on the new address (e.g. ping)
Preference File
Software preferences are stored in the file :
C:\Nucoda2014_1\root\general.prefs
The telecineControl section specifies the IP address assigned to Eth1 (Nucoda
LAN) e.g.
telecineControl
{
address "192.168.25.1"
port "420"
}
note
The address option is the IP address of the Eth1 port (Nucoda LAN). You should not
change this unless you also change the Telecine Controller IP address (see page
69).
Use
Telecine transport controls are available in the List Capture/VTR Capture screen.
In addition, the optional Picture Control functionality is available via the tab Telecine
Settings inside the VTR Capture window.
Figure 35 : Telecine Settings menu inside VTR Capture
window.
IM-2014_1-1.0 Page 70