Installation manual

Telecine Control Nucoda and Phoenix 2014 Install Manual
note
An RS232/422 converter is included with the package.
Configuration
Ethernet LAN
By default, the ethernet LAN ports are configured as follows :
Port (Internal Name) IP Address Use
Eth0 (vrr0) 10.1.3.251 To Telecine
Do not change this
13
See note below.
Eth1 (vrr1) 192.168.25.1 To Nucoda
A dedicated link is preferred.
Changing Nucoda LAN Address
alert!
This procedure is for advanced users only!
If you need to change the default IP address Nucoda LAN port (Eth1), follow these
instructions :
● Connect a cross-over ethernet cable to Eth1
● Use an SSH client
14
to connect via SSH to the Telecine unit
user astec
pass astec
port 22
● Switch to superuser :
su <enter>
pass astec
● Edit the file
15
: /etc/rc.local
● Change the vrr1 line to reflect your desired IP address e.g.
ifconfig vrr1 <New IP> netmask 0xffffff00
13 The Eth0 ethernet connection does not use TCP/IP for communications to the Spirit
Classic or Shadow Telecine. As such, the IP address is not used and does not need
configuration.
14 On Windows, you can use a free SSH client such as PuTTY available from :
http://www.chiark.greenend.org.uk/~sgtatham/putty/
15 You will need to use the vi editor.
IM-2014_1-1.0 Page 69