Installation manual

THX Cinespace Nucoda and Phoenix 2014 Install Manual
· Switch to the Colour tab
· Choose Linear (SMPTE) as the colour scaling mode
· Switch to the System screen
· Press the Listen to cineProfiler button
When enabled, the application prints :
Listening for cineProfiler plugin events …
note
Our application listens on a TCP/IP port for communication from the cineProfiler
application. By default, this port is 9988 but you can set this in the general.prefs file
(see page 37) CineProfilerServer section :
CineProfilerServer
{
port 9988
}
cineprofiler
Attach the calibration probe to the system.
note
The probe can be directly attached to the system running cineProfiler or on a different
system by using the THX probeServer application.
Choose the following settings :
· Viewing Device : Projector
IM-2014_1-1.0 Page 61