Installation manual

THX Cinespace Nucoda and Phoenix 2014 Install Manual
Figure 31: Profiling using the Nucoda plug-in to cineProfiler
Procedure
We need to configure the Digital Vision application and cineProfiler application
separately.
Digital Vision Application
Start the software and ensure we are monitoring through the correct device. In general,
this will be via the video I/O device (e.g. DVS Atomix LT).
· On the main project screen, switch to the Preferences screen
· Then the Monitoring/Video IO tab
· Check that Enable SDI IO Card is on
Also set the desired SDI Link and format and enable :
Always use default format for monitoring
IM-2014_1-1.0 Page 60