Installation manual

VTR Remote Mode Nucoda and Phoenix 2014 Install Manual
VTR Remote Mode
VTR Remote Mode configures the Digital Vision application to respond as if it was a
VTR device under RS422 remote control.
We can control the Digital Vision application from a VTR device (stop, play, rewind, jog)
via the RS422 control cable.
note
VTR Remote Mode is supported with Centaurus2 video boards.
Note that the RS422 cable is connected in the opposite orientation compared to that
used for normal VTR control from the Digital Vision application.
Application Configuration
Enable VTR Remote Mode inside the Digital Vision application by pressing the Remote
button to the left of the play controls :
Once enabled, the button turns orange : and a locator window opens displaying
your current timeline position.
alert!
The timeline should be fully rendered for VTR Remote Mode to work correctly.
IM-2014_1-1.0 Page 56
Figure 29 Remote button
Figure 28 RS422 connection for VTR Remote mode