Installation manual

DVS Centaurus II Video Nucoda and Phoenix 2014 Install Manual
Options on page 12).
● On 32 bit Windows, install the 32 bit driver
● On 64 bit Windows, install the 64 bit driver
Centaurus Firmware
During the driver install, a CMD window will open and prompt you to update the card
firmware. If you enter Y when prompted and press the <ENTER> key, the firmware will
be flashed. You only need to do this once.
note
After driver installation, you will need to reboot.
DVS Utility Programs
We install a selection of DVS utility programs that help configure the video board,
retrieve card information and perform some basic trouble-shooting.
The programs are installed in folder :
C:\Program Files\Digital Vision\2014_1\DVS_2014_1\
dvsconf
The dvsconf program displays card information, such as driver/firmware levels and
licensed options. It also allows you to run various tests and diagnostics on the hardware.
Driver and Firmware Revisions
The firmware revision is shown after the HW label.
Licensed Options
To see a list of licensed options installed on the card, on the Card 0 tab, press the
Setup button and choose Info License (see 27 below).
Figure 27 : Centaurus installed license information.
IM-2014_1-1.0 Page 53