Installation manual

DVS Centaurus II Video Nucoda and Phoenix 2014 Install Manual
DVS Centaurus II Video
Digital Vision 2014 applications support the DVS Centaurus II and Centaurus II LT video
cards. These can be used for video I/O (capture/layoff), audio ingest (embedded/AES),
VTR machine control and monitoring.
Hardware
Our workstation solutions incorporate the main Centaurus II board for the SDI A
channels, alongside a slot used for the SDI B channels
10
and the RS422 remote
connector (using a breakout cable).
Figure 26 : Centaurus II PCI video board alongside the SDI B channel board.
Audio
You can use embedded audio or AES via the AES connector /breakout cable
11
.
To monitor audio using the Centaurus II video board, start the Digital Vision 2014.1
application and on the main screen, select the Preferences/Monitoring tab and enable
the Use Video IO card as audio monitor tick box :
Driver Installation
If you have a DVS Centaurus II video board, you should install a driver as part of the
main application install by ticking the Install DVS Centaurus II driver box (see Install
10 No electrical connection is required for the SDI B card.
11 The AES option panel may not be installed inside your system.
IM-2014_1-1.0 Page 52