Installation manual

Control Panels Nucoda and Phoenix 2014 Install Manual
Valhall Panel IP Addresses
By default, the Valhall panel network port is set to :
IP address : 192.168.64.2
Subnet mask : 255.255.255.0
note
If you need to change the Valhall panel default IP address, see Changing Valhall IP
Address below.
Environment
An environment variable is created during application installation (if Valhall checkbox is
ticked) and set to the default IP address of the panel.
Variable Value
DV_VALHALL_PANEL
192.168.64.2
Changing Valhall IP Address
By default, the Valhall panel has an IP address of 192.168.64.2.
To change this press and hold the Event and Enter keys on the Image Panel when
powering it up. After the panel initialisation, instructions for changing the panel IP
address will appear in the LED display as shown in 12 below.
Figure 12 : Image Panel - Press Event + Enter keys on power-up.
Instructions will appear in the large LED panel at the top of the Image panel.
Use the four knobs below the LED display to change the IP address. Once complete,
save the new address by pressing the BookM and Enter keys.
note
The LED instructions tell you to use the Shift key. However, keys have been moved
and for the Nucoda products, the Shift key referred to is now BookM.
For 2014 application use, you will also need to :
IM-2014_1-1.0 Page 24