Installation manual

Control Panels Nucoda and Phoenix 2014 Install Manual
Valhall
Valhall Control Panels consist of four user panels and a Power and Communications
Unit (PCU)
6
:
● Media, Image, Colour and Scribe (tablet) panels
● PCU power/communications
Cabling
The panels connect to the PCU using special cables and the PCU connects to the host
computer via a cross-over ethernet cable. This is shown in 11 below.
Figure 11 : Valhall Control Panel connections
Ethernet Setup
Host IP Address
By default, the host computer network port is set to :
IP address : 192.168.64.1
Subnet mask : 255.255.255.0
No other settings are required (gateway, DNS etc.).
note
If you need to change the host computer IP address, see the appendix Setting Host
IP Address on page 74. If you change this, you will also need to set the appropriate
panel IP addresses as well (see below).
6 Newer Mark 2 Valhall panels use a PCU. Older Mark 1 Valhall panels have the PCU
integrated inside the Image panel.
IM-2014_1-1.0 Page 23