Installation manual

Control Panels Nucoda and Phoenix 2014 Install Manual
configured to be on the same TCP/IP subnet as the panel network.
3. Make sure you can ping each panel from the host computer.
4. Disable any Windows firewall on the host computer network port connected to
the panels.
Precision Emulator
A Precision Panel software emulator program is included with the application. This is a
fully emulated version of the Precision Panel and behaves in the same way as the actual
hardware. You can use the emulated panel controls and interact with a running Nucoda
application as if you had a real panel.
note
The Precision Emulator works with Nucoda Film Master and Nucoda Fuse. The
Nucoda Fuse version emulates the Precision Colour panel only.
Starting the Emulator
The emulator is started via a BATCH file. This is linked on your desktop after install and
also located under the application folder :
• Desktop\Precision Emulator 2014.1
• C:\Nucoda\Precision - Emulator\Precision Emulator 2014.1.bat
To start the emulator :
• Double-click a batch (.bat) file e.g.
Desktop\Precision Emulator 2014.1
The batch file :
• Sets up the Precision Panel environment
• Starts the emulator (Precision.exe)
• Starts the Nucoda application
Once the Nucoda application initialises the emulated panel, the panel displays its
welcome screens as usual :
IM-2014_1-1.0 Page 22