Installation manual

Control Panels Nucoda and Phoenix 2014 Install Manual
2. Set the Current Directory to the folder containing the firmware files (use the
Browse button to set this)
3. The Server Interface shown should be the IP address of the host computer
network port which is connected to the Precision panel.
note
The Server Interface address shown should match the IP address used to set the
Server Address in the Precision panel IP Configuration steps as described above.
4. Power cycle each panel in turn, while holding down the Lock button on each
(the left Lock button on Precision Colour) (see below)
The firmware files will be sent from the host computer to each panel by tftpd32.
On completion, each panel will reboot automatically.
5. On restart, check the firmware version and make sure the update was
successful.
6. Repeat this procedure for each panel in turn.
Troubleshooting the Firmware Update Process
If you have problems with the firmware update, check the following points :
1. Check that each panel has the expected IP address configuration.
2. Make sure that the host computer network port connected to the panels is
IM-2014_1-1.0 Page 21