Installation manual

Control Panels Nucoda and Phoenix 2014 Install Manual
5. Press the joystick button to select and enter the IP Configuration menu.
The IP Configuration menu will look similar to the following (example only) :
Current Address eth0: 192.168.21.1 (00:50:c2:xx:xx:xx)
Current Address eth1: (00:50:c2:xx:xx:xx)
Mask: 255.255.255.0
Server Address: 192.168.21.100
Use DHCP: NO
< Exit
Figure 10 : Joystick navigation and adjustment knobs.
6. The ethernet port used is listed at the top :
Current Address eth0 :
7. Set the eth0 address
With Current Address eth0: selected (and highlighted in red), use the four knobs
below the display (as shown in 10 above) to adjust the IP address components.
8. Set the Server Address
Now use the joystick to select the Server Address option. Then use the four
knobs below the display to set this to the IP address of the host computer system.
note
The host computer is a system on your local network, probably one running the
Digital Vision application. You only need to configure the Server Address to enable a
firmware update from the host computer with the specified IP address.
9. Once done, use the joystick to select :
Reboot
note
Remember that each panel has a separate ethernet port and TCP/IP address. Each
is configured using the same process as described above.
alert!
If you change the IP address of any of the Precision panels, you will also need to
update the environment variable e.g. NUCODA_PRECISIONPANEL or
NUCODA_PRECISIONCOLOUR (for Nucoda Fuse).
IM-2014_1-1.0 Page 19