Installation manual

Control Panels Nucoda and Phoenix 2014 Install Manual
No other settings are required (gateway, DNS etc.).
note
If you need to change the host computer IP address, see the appendix Setting Host
IP Address on page 74. If you change this, you will also need to set the appropriate
panel IP addresses as well (see below).
Setting the Precision IP Addresses
To change the Precision panel IP addresses, enter the panel configuration menu.
1. Enter the configuration menu by holding the Tools button on the panel when
powering it up (the left Tools button on the Precision Colour panel) :
2. Once powered up, the panel configuration screen will be shown.
3. Use the left joystick to navigate the menus :
• up /down options
• press to select
4. Select :
IP Configuration>
The IP Configuration screen will display the current IP address settings and let
you change them.
note
The currently selected option will be highlighted in red.
IM-2014_1-1.0 Page 18