Installation manual

Control Panels Nucoda and Phoenix 2014 Install Manual
Network
Ethernet Port
Each panel has two ethernet ports. Use the top one :
Figure 9 : Precision Control Panel ethernet and power connections
Panel IP Addresses
The Precision panels have the following TCP/IP network addresses y default :
Precision Panel IP Address
Colour 192.168.21.1
Transport 192.168.21.2
Touch 192.168.21.3
note
If you need to change the Precision panel default IP address, see page 18 below.
Environment
If you tick the Precision Control Panel option during software installation, an
environment variable is created and lists the default IP addresses of all Precision
panels, comma separated.
Variable Value
NUCODA_PRECISIONPANEL
192.168.21.1,2,3
note
For Nucoda Fuse, this environment variable will be : NUCODA_PRECISIONCOLOUR
Host IP Address and Settings
By default, the host computer network port connected to the panels is set to :
IP address : 192.168.21.4
Subnet mask : 255.255.255.0
IM-2014_1-1.0 Page 17