Installation guide

A-7
Appendix
2
1
3
I
4
A
A.6 Signal In- and Outputs
This section provides pin-out information about some of the connectors
provided by Atomix LT.
AUX Breakout for Breakout Cable (15-Pin D-Sub HD
Connector)
The RS-422 port provided via the breakout cable is RMT In/Out 1. It
can be switched between master and slave mode via the software.
Analog Audio (3.5 mm Headphone Jack)
Pin No. Signal Pin No. Signal
1Genlock IN 9–
2 RS422_TX 10 DigGND
3 /RS422_TX 11 /LTC_TX
4 LTC_TX 12 LTC_RX
5 Audio Right 13 RS422_RX
6 Genlock GND 14 /RS422_RX
7 DigGND 15 /LTC_RX
8 Audio Left
Output Impedance 75 Ohm
Output Level 1.55 V (at 600 Ohm)