Installation guide

A-5
Appendix
2
1
3
I
4
A
A.5 GPI (Optocoupler)
This section provides further details about the GPI based on optocou-
pler technology (see section “GPI Panel” on page 2-14).
A.5.1 Technical Data
The following shows some technical data of the optocoupler GPI:
A.5.2 Block Diagrams
This section shows block diagrams of the GPI in- and output.
GPI Input
The inputs turn on if you feed a current between 2 mA and 40 mA to
the positive pins, negative must then be connected to ground.
Output DC or peak AC load voltage 200 V
continuous DC load current 200 mA bidirectional
Input min. voltage to turn to ON 2 V DC
max. voltage to turn to ON 14 V DC