Installation guide

3-13
Installation
3
2
1
I
4
A
The new license key is now set and will be stored non-volatile in
Atomix LT.
 Repeat the described steps to activate the features for the second
key (’keyfile2’), if appropriate, by altering the command respec-
tively.
 If you have more than one Atomix LT board installed in your com-
puter system, use the environment variable SCSIVIDEO_CMD to
access the respective board and repeat the steps to activate its fea-
tures.
 Reboot the computer system.
Once the system has started, all licensed features will be available to
Atomix LT.
The features activated with this license key can be checked
with the command svram licence show.
It is recommended to have the latest released firmware version
installed on the Atomix LT board. More information about this
can be found in section “Upgrading the Firmware” on
page 3-14.
To be sure your Atomix LT board works properly, you may also
test your installation. Details on how to perform a testing of
your installation can be found in section “Testing the Installa-
tion” on page 3-17.