Installation guide

3-11
Installation
3
2
1
I
4
A
3.1.5 Finishing the Installation
This step of installing the Atomix LT board is the last step to be per-
formed. To finish the hardware installation do the following:
 Close the computer casing.
 Connect all cables to the computer system again.
 Connect your audio and video equipment to the Atomix LT connec-
tors.
 After this start the computer system.
Once the computer system has finished the loading of the operating
system, the installation of the hardware of Atomix LT is complete. To
use the board and activate its features you have to install the DVS soft-
ware as well (see section “Software Installation” on page 3-12).