Installation guide

3-12
Atomix HDMI Installation Guide
The new license key is now set and will be stored non-volatile in Atomix
HDMI.
 Repeat the described steps to activate the features for the second
key (’keyfile2’), if appropriate, by altering the command respec-
tively.
 If you have more than one Atomix HDMI board installed in your
computer system, use the environment variable SCSIVIDEO_CMD
to access the respective board and repeat the steps to activate its
features.
 Reboot the computer system.
Once the system has started, all licensed features will be available to
Atomix HDMI.
The features activated with this license key can be checked
with the command svram licence show.
It is recommended to have the latest released firmware version
installed on the Atomix HDMI board. More information about
this can be found in section “Upgrading the Firmware” on
page 3-13.
To be sure your Atomix HDMI board works properly, you may
also test your installation. Details on how to perform a testing
of your installation can be found in section “Testing the Instal-
lation” on page 3-16.