Installation guide

2-14
Atomix HDMI Installation Guide
2.3.5 RS-422 Panel
The RS-422 panel provides two DB-9 connectors for a standard RS-422
connection for remote control.
Pin-outs of the DB-9 connectors can be found in section “Signal In- and
Outputs” on page A-5. The pin-outs of the RS-422 ports can be
switched between master and slave mode in the software.
Figure 2-8: Panel with remote control connections
Item Explanation
RMT In/Out 1 DB-9 connector (female), serial RS-422 inter-
face for master or slave control
RMT In/Out 2 DB-9 connector (female), serial RS-422 inter-
face for master or slave control
RMT In/Out 2
RMT In/Out 1