Installation guide

2-12
Atomix HDMI Installation Guide
2.3.4 Audio Panel
Up to two audio panels can be included in your Atomix HDMI delivery
(see section “Note About the Audio Setup” on page 2-9). They provide
each a DB-25 connector for digital audio (AES/EBU). One of the panels
provides also an analog stereo headphone output and can be config-
ured to transmit LTC signals.
To the DB-25 connectors you can connect breakout cables providing
each eight XLR connectors to interface directly with audio devices. Pin-
outs of the DB-25 connectors can be found in section “Signal In- and
Outputs” on page A-5.
Item Explanation
Digital Audio
(AES/EBU)
DB-25 connector (female) for audio and LTC
in- and output; provides either four stereo
channels digital audio (channels 1 to 8) or
three channels audio plus LTC; alternatively it
can be used to provide the digital audio
channels 9 to 16
Remote In/Out DB-9 connector (female), serial RS-422 inter-
face for master or slave control
In a setup that contains this panel as well as one of the audio
panels described in section “Audio Panel” on page 2-12, it is
recommended to install it as audio panel #2 (see section “Note
About the Audio Setup” on page 2-9).
Prior to the installation of the panel you have to set/check the
jumpers on the printed circuit boards for the appropriate set-
tings (see section “Jumper Settings of the Audio and RS-422
Panel” on page 3-3).