Installation guide

2-11
Overview
2
1
3
I
4
A
2.3.3 Audio and RS-422 Panel
The audio and RS-422 panel provides a DB-25 connector for digital au-
dio (AES/EBU) and LTC signals as well as a DB-9 connector for a stan-
dard RS-422 connection for remote control.
To the DB-25 connector you can connect a breakout cable providing
eight XLR connectors to interface directly with audio devices. The pin-
out of the RS-422 port can be can be switched between master and
slave mode in the software. Pin-outs of the DB-9 and DB-25 connectors
can be found in section “Signal In- and Outputs” on page A-5.
Figure 2-6: Panel with audio and remote control connections
SDI Out A BNC connector for an output of digital video
signals (serial digital interface, port A); usually
used for an output of the first video channel in
single-link (YUV) or dual-link modes (either
3-Gbit/s SDI or first dual-link stream of YUVA
or RGB[A])
SDI Out B BNC connector for an output of digital video
signals (serial digital interface, port B); usually
used for an output of the second video channel
in single-link (YUV) or dual-link modes
(3-Gbit/s SDI); can also be used for the first
video channel for the second dual-link stream
of YUVA or RGB[A]
Item Explanation
Digital Audio (AES/EBU)
Remote In/Out