Installation guide

2-6
Atomix HDMI Installation Guide
2.2.3 Overview of the Soldering Side
This section shows the operation items located at the soldering side of
the PCI video board. They can be found at the top left of the soldering
side:
Figure 2-4: Items on the Atomix HDMI board’s soldering side
14 breaking line The printed circuit board provides at its bottom
an extension void of any electrical parts; it may
serve to stabilize the installation of the board in
a computer system; when not needed or inter-
fering, you can carefully break it off the circuit
board at the breaking line
Item Explanation
DIP switch for Flash
controller
Controls the operation of the on-board Flash
controller. It determines whether the main or
the fallback map will be loaded at startup (see
also chapter “Maintenance” on page 4-1).
Default/factory setting of the DIP
switch for the Flash controller (main
map). Please observe the orientation
of the switch on the board.
For normal operations the default
setting has to be used.
No. Item Explanation
DIP switch LEDs