Specifications

ManualsBrandsDVS ManualsHome building and Decor-30RF-2

27 NC No connection

28 NC No connection

29 BA0 Data bit B0

30 BA1 Data bit B1

31 BA2 Data bit B2

32 BA3 Data bit B3

33 BA4 Data bit B4

34 BA5 Data bit B5

35 BA6 Data bit B6

36 BA7 Data bit B7

37 GND Ground

38 GND Ground

39 VS Vertical sync

40 CLK Dot clock

41 HS Horizontal sync

42 DE Display enable

43 PWR Power down control signal (5v TTL)

44 VLCD Panel power supply (3,3V/5V) (selected by JA3 & JA6)

45 VLCD Panel power supply (3,3V/5V) (selected by JA3 & JA6)

46 VLCD Panel power supply (3,3V/5V) (selected by JA3 & JA6)

47 NC No connection

48 VLCD12/18 +12V/18V panel supply (selected by JA3 & JA6)

49 VLCD12/18 +12V/18V panel supply (selected by JA3 & JA6)

50 VLCD12/18 +12V/18V panel supply (selected by JA3 & JA6)

CNA1 - Auxiliary power output: JST B4B-XH-A (Matching type : XHP-4)

PIN SYMBOL DESCRIPTION

1 AUX POWER +12V DC, 500mA max / +24V DC, 3A max

2 GND Ground

3 GND Ground

4 AUX 5V +5V DC, 500mA max

CNB1 – Backlight inverter connector: JST B5B-XH-A (Matching type : XHP-5)

PIN SYMBOL DESCRIPTION

1 GND Ground

2 VBKL Backlight power supply, +12VDC / +24V DC, 3A max

3 BLCTRL Backlight On/Off control signal (refer to JB2 & JB3)

4 BVR_WIP Backlight brightness VR pin WIP

5 BVR_A Backlight brightness VR pin A

CNB2 – Backlight status connector : JST B2B-XH-A (Matching type : XHP-2)

PIN SYMBOL DESCRIPTION

1 BL_S Backlight status signal

2 GND Ground

CNC1 – Control switch, JST B12B-XH-A

PIN SYMBOL DESCRIPTION

1 PSWIN Power button A

2 SW_ON Power button B

3 BVR_A Backlight Brightness VR pin A

4 BVR_WIP Backlight Brightness R pin WIP

5 BVR_B Backlight Brightness VR pin B (470 ohm resistor to +5V Vcc)

6 GND Ground

7 MENU OSD menu

8 -/LEFT OSD -/Left

9 +/RIGHT OSD +/Right

10 SEL_DN OSD Select down

11 SEL_UP OSD Select up

12 NC No connection

CNV1 – Alternate Video in input, JST B5B-PH-K (Matching type : PHR-5)

PIN DESCRIPTION

1 S-Video : Chroma in

2 S-Video : Luma in

3 Ground

4 Ground

5 Composite video 1 in

LED1 – Controller status LED connector: 3-pin header

PIN DESCRIPTION

1 Green LED pin (anode)

2 LED pin common (cathode)