User's Manual

1-3. Upgrade directions
1-4. Troubleshooting
1) Touching does not work
If you cannot set touching in the Setup menu due to wrong touch setting, use
the remote controller instead.
Ș Press the [Initial Screen] button on the remote controller to open the main menu
screen.
Ș Press the [F2] ơ [F3] ơ [F2] ơ [Full Screen] button sequentially to open the Touch
Setting screen
Ș Press the 5 cross marks using the test jack or touch adjustment rod, according to the
instructions displayed on the screen.
Ș Press the screen once to close the Touch Setting screen.
2) The LED turns on or flashes in red resulting in the VXA-3000 self-diagnostic
Addition to the VXA-3000 problem, when the temperature inside the car is too high
or low, the red LED flashes. In this case, follow the steps below.
Ș Turn the product power off and ventilate the car to get normal temperature.
Ș Turn the power on after a little while and observe the LED color.
Ș If the red LED still flashes in normal temperature, ask for the service at A/S center.
5
About VXA-3000
Ș Depending on the SD Card memory product, the SD Card memory sensing time may vary
or sensing may fail.
VXA-3000
Park the car in a safe place for touch setting.
Basic Operation
Caution