User's Manual

1-3. Upgrade directions

1-4. Troubleshooting

1) Touchscreen does not work

If you cannot set up the touchscreen in the Setup menu due to wrong setting, use the remote

controller instead.

Ș Press the [Initial Screen] button on the remote controller to open the main menu

screen.

Ș Press the [F2] Ɗ [F3] Ɗ [F2] Ɗ [Full Screen] button sequentially to open the Touch

Setting screen

Ș Press the 5 cross marks using the test jack or touch adjustment rod, according to the

instructions displayed on the screen.

Ș Press the screen once to close the Touch Setting screen.

2) The LED turns on or flashes in red during self-diagnostic:

In addition, when the temperature inside the car is too high or low, the red LED flashes. In this

case, follow the steps below.

Ș Turn the product power off and ventilate the car to get normal temperature.

Ș Turn the power on after a little while and observe the LED color.

Ș If the red LED still flashes in normal temperature, contact customer service.

About Navigation System

Ș Depending on the SD Card memory product, the SD Card memory sensing time may vary

or sensing may fail.

Ș Below list is recommended SD card.

Ș Some SD cards work better than others. Please contact customer support (page 77) if you

need further assistance.

Navigation System

Park the car in a safe place for touchscreen setting.

Basic Operation

Caution

8:7,=+<;

<ZMV[MVL

891

;IU[]VO

0IVJQ\

8ZM\MK

BaZ][

1UI\QWV

0IOQ_IZI

<_QV57;

5

AM[

5

AM[

/

AM[

;8--,

[XMMLIVL

TM[[