User manual
4 / 8-channel H.264 DVR User Manual
23
The power system should not be interrupted during updating.
DEFAULT
DEFAULT
DEFAULT
DEFAULT SETTING
SETTING
SETTING
SETTING : Restore the system parameters to the default settings.
RESTART
RESTART
RESTART
RESTART :
:
:
: Restart this unit.
3.7.6
3.7.6
3.7.6
3.7.6 PTZ
PTZ
PTZ
PTZ
Enter the “ PTZ ” screen from “ Main Menu ” →“ Advanced ” , as shown below:
Channel
Channel
Channel
Channel : selecting the channel to which the dome camera is connected (to select any
of the latter 4 channels, click “ Next Page ” )
Protocol
Protocol
Protocol
Protocol : selecting the dome protocol of the corresponding brand and model, with two
options, Pelco-D by default
Baud
Baud
Baud
Baud rate
rate
rate
rate : selecting the baud rate used by the dome, with the 4 options of 1200, 2400,
4800 and 9600
Data
Data
Data
Data bit
bit
bit
bit : with the options of 5, 6, 7 and 8, 8 by default
Stop
Stop
Stop
Stop bit
bit
bit
bit : with the options of 1 and 2, 1 by default
VERIFY
VERIFY
VERIFY
VERIFY :
:
:
: with the 5 options of None/Odd/Even/Mark/Space, None by default
Address
Address
Address
Address : Complete the PTZ code of the corresponding channel.
Just
Just
Just
Just set
set
set
set “
“
“
“ protocol
protocol
protocol
protocol ”
”
”
” ,
,
,
, “
“
“
“ baud
baud
baud
baud rate
rate
rate
rate ”
”
”
” and
and
and
and “
“
“
“ address
address
address
address code
code
code
code ”
”
”
” in
in
in
in order
order
order
order to
to
to
to set
set
set
set the
the
the
the PTZ.
PTZ.
PTZ.
PTZ.
See “ Shortcut Menu ” →“ PTZ Control ” for PTZ control.
3.7.7
3.7.7
3.7.7
3.7.7 Network
Network
Network
Network setup
setup
setup
setup
Enter the “ Network ” screen from “ Main Menu ” →“ Advanced ” , as shown below:
TYPE
TYPE
TYPE
TYPE :
:
:
: with 3 options: static configuration, DHCP and PPPOE
Static
Static
Static
Static : allocating an IP address manually
DHCP
DHCP
DHCP
DHCP : acquiring an IP address automatically
After selecting the DHCP mode, restart the system after confirmation. After starting, the
system will establish a connection with the DHCP server automatically. When this is