Specifications

WPS-100-DVR-8CH Installation and Users Manual

 •LOG

By default, the DVR will log when video loss is detected to the Event Log.

 •E-MAIL

  ThisDVRcansendanemailmessagetoapredenedemailaddressintheeventvideolossisdetectedfor

this camera. The default setting is disabled. See Section Section 9.3.11 for more information on e-mail.

 •FTP

This DVR can send the recorded video loss event for this camera to a FTP server. The default setting

is disabled.

 •SCREENMESSAGE

By default, the DVR will display a video loss message in the System Status Bar (visible from the VGA

or BNC main monitor output only) when video loss is detected for this camera.

9.3.8 ALARM

The Alarm Setupallowstheadministratortodenetheattributesforeachalarminputandtheactionsifit

is triggered. Up to four alarm inputs such as motion detectors or door contacts that can be connected

to the DVR.

Thefollowingisabriefdescriptionforeachiteminthismenuanditsspecicoperations:

 •NORMALSTATE

Select N/A, Close or Open. The type of sensor connected to the DVR will determine the setting.

For example, motion detectors typically are normally open while door contacts are normally closed.

Select N/A (Not Available) if the input is not used and the following items will not be adjustable. The

default setting is Open.

 •FOCUSCAMERA

The camera associated with the alarm input.

 •DURATION

Set the length of time the buzzer and the corresponding Alarm Out relay will remain triggered once

the alarm input is triggered. The buzzer and Alarm Out relay will reset immediately once motion is no

longer detected. If ‘-‘forindeniteisselected,theAlarmResetbuttonontheremotecontrolwillhave

to be pushed to reset the alarm.