Specifications

69
WPS-100-DVR-4CH Installation and Users Manual
© 2012 Wirepath Surveillance
The following is a brief description for each item in this menu and its specic operations:
• CAMERA
Select the camera to dene motion triggered events.
• DURATION
Set the length of time the buzzer and the corresponding Alarm Out relay will remain triggered once
motion is detected for this camera. The buzzer and Alarm Out relay will reset immediately once motion
is no longer detected.
• CAMERA TO GO
This feature is not available on WPS-100-DVR-4CH.
• GOTO PRESET
This feature is not available on WPS-100-DVR-4CH.
• PRE-RECORD
Dene how much time the DVR will record before motion is detected. The Pre Record FPS set in Section
9.3.5 determines the frame rate of this recording.
Note: Actual pre-record time may be shorter than the value set if the total size of the pre-record video
exceeds the pre-record video buffer.
• POST-RECORD
Dene how much time the DVR will record after motion is detected. The Post Record FPS set in Section
9.3.5 determines the frame rate of this recording.
• ALARM OUT
This feature is not available on WPS-100-DVR-4CH.
• BUZZER
By default, the internal buzzer is disabled to sound when motion for this camera is detected.
• LOG
By default, the DVR will log to the Event Log when motion is detected.
• E-MAIL
Send an E-mail message to pre-dened E-mail address in the event motion detected for this camera.
See Section 9.3.11 for more information on E-mail.
• FTP
This feature is not available on WPS-100-DVR-4CH.
• SCREEN MESSAGE
By default, the DVR will display a motion detection message in the System Status Bar (visible from the VGA
or BNC main monitor output only) when motion is detected for this camera.