Specifications

WPS-100-DVR-4CH Installation and Users Manual

Following is a brief description for each item and its specic operations:

• DURATION

Set the length of time the buzzer and the corresponding Alarm Out relay will remain triggered once video

loss is detected for this camera. The Buzzer and Alarm Out relay will reset immediately once video signal is

restored. Press +/- buttons to adjust the value from 3 seconds to 60 minutes or ‘-‘ for indenite requiring an

Alarm Reset.

• PRE-RECORD

Pre-Record denes how much time the DVR will record before video loss is detected. The Pre Record FPS

set in Section 6.2 determines the frame rate of this recording. Press +/- buttons on the remote control to

adjust the value from 0 to 10 seconds. Alternatively, use the mouse to adjust this setting.

Note that the actual pre-record time may be shorter than the value set if the total size of the pre-record

video exceeds the pre-record video buffer.

• POST-RECORD

Dene how much time the DVR will record after motion is detected. The Post Record FPS set in Section 6.2

determines the frame rate of this recording. Press +/- buttons on the remote control to adjust the value

from 0 to 60 minutes. Alternatively, use the mouse to adjust this setting.

• DETECTION

See 6.1.1.1 Detection Settings for detail on the available settings.

• BUZZER

By default, the internal buzzer is enabled to sound when video loss for the camera is detected. Highlight

this setting and press ENTER or +/- to enable or disable this item. Alternatively, use the mouse to left-click

on this item.

• LOG

By default, the DVR will log when video loss is detected to the Event Log (see Section xx). Highlight this set

ting and press ENTER or +/- to enable or disable this item. Alternatively, you can use the mouse by left

clicking in the box next to Buzzer in the current dialog window.

• E-MAIL

This DVR can send an email message to a predened email address in the event video loss is detected

for this camera. Highlight this setting and press ENTER or +/- to enable or disable this item. Alternatively,

use the mouse to left-click on this item. The default setting is disabled. See Section 6.4.1 for more

information on e-mail.

• DETECTION SETTINGS

See Section 6.1.1.1 Detection Settings for detail on the available settings.