Specifications

WPS-100-DVR-4CH Installation and Users Manual

• CONNECT/DISCONNECT

If the backup device is disconnected (as shown in screen capture above), plug the USB device into the

USB 2.0 port and then press ENTER on the remote control. Alternatively, use the mouse to click on the

CONNECT button. If the device is already plugged in, press ENTER on the remote control to connect the

device. Alternatively, use the mouse to click on CONNECT. It is recommended to select the DISCONNECT

option before unplugging the USB device.

Note 1: Before using a USB drive, format it to FAT32 le system using Windows.

Note 2: The backup device must be connected by the system software before it can be used to read/

write. If it fails to connect, unplug the device and then plug the device into the USB port again.

Note 3: Some backup devices may have compatibility problems. See the list of tested devices below.

• BACKUP

Once a device is connected, use the ▲▼◄► buttons on the remote control to select BACKUP for the

corresponding USB device and press ENTER. Alternatively, use the mouse to select this button. Enter the

directory to backup the congurations to. This button will remain white in color and unavailable until a USB

device is connected.

• RESTORE

Once a device is connected, use the ▲▼◄► buttons on the remote control to select RESTORE for the cor

responding USB device and press ENTER. Alternatively, use the mouse to select this button. Enter the

directory to restore the congurations from. This button will remain white in color and unavailable until a

USB device is connected.