User manual

17
Preset point is a convenient usage of PTZ camera. It is a preset user-defined camera position; user can
move the camera position very quickly when needed.
Total programmable capacity of 16 preset locations.
4.6 Relay Output
The relay device should be set to NO (Normal Open) and it will change to NC (Normal Close) when an event
has been triggered.
Enter EVENT -> RELAY OUTPUT menu to select the Relay type which connected with DVR.
DVR provides a Relay output interface; the following events will trigger off the Relay signal:
<RELAY SELECT>
ALARM: Sensor Input
LOSS: Video Loss
MOTION: Motion Detection
HDD ERROR: HDD failed
POWER (NC): Please set the relay device to NC so that once power-loss occurs, it will change to NO.
USER: Manual Relay Output
NOTE: Use the FUNCTION button to enter the manual Relay mode
- NC→NO: Press the F(+) button
- NO→NC: Press the F(-) button
- Press the FUNCTION button again to exit this mode
REC: Record break
NOT USED: Disable relay output function
<RELAY OUTPUT TIME>: 1~30 sec.