User manual

English _45
 USING THE DVR
Setting the Spot Out
You can set the DVR to output information / video apart from the monitor out.
Using the mouse may help make setup easier.
1. Use the up/down buttons (  ) in <Device> window to
move to <Monitor>, and press [ENTER] button.
2. Select <Spot Out>.
 The number of Spot Out terminals differs according to the
model.
3. Use direction buttons ( ◄ ► ) to move to a desired
item, and set the value.
• Spot Out 1 : You can select between Auto Sequence, and
Single.
• Set Mode : A window for “Set Spot Out” appears and you
can set the channel for it.
You can set the dwell time between the screen switching in
“Setting the Device > Camera > SEQ-Dwell Time”.
(Page 39)
• Event Display :
Specify the time to display the channel
where an event took place on the spot screen.
If selected <Continuous>, it displays the channel until you
press [ALARM] button to release it.
M
 You can setup using the mouse right button in Live screen.
Refer to “Spot Out”. (Page 25)
4. When the Spot Out is done, press <OK>.
Setting the Screen Mode
You can configure the Live screen and Split Screens.
Using the mouse may help make setup easier.
1. Use the up/down buttons (  ) in <Device> window to
move to <Monitor>, and press [ENTER] button.
2. Select <Mode>.
3. Use direction buttons (
◄ ► ) to move to a desired
item, and set the value.
• Live Screen : Select split modes for the Live screen.
16-, 9-, and 4-split screens are included by default.
• Play Screen : Select split modes for the playback screen.
Only the 13-split screen is optional.
Black shows the playback while white shows the Live screen.
4. When the screen mode setup is done, press <OK>.
Monitor
Spot Out
Monitor

Spot Out 1 SEQ
Mode
OK Cancel
Set Mode
All
Monitor
Mode
Monitor Spot Out
OK Cancel
Live Play

Live Screen

Play Screen

Event Display OFF
Monitor
Spot Out
Monitor

Spot Out 1 SEQ
Mode
OK Cancel
Set Mode
All

Event Display OFF
Set Spot Out
OK
1 2 3 4
5 6 7 8
9 10 11 12
13 14 15 16