User`s guide

36 | P a g e
3-3. Setup – Record Mode
In the SETUP menu, select the RECORD tab. Then, the RECORD menu is displayed as pictured below. Navigate through
the menu items using the mouse or the control button on the remote control and change the value of the menu item.
Figure 3.3.1. Recording Mode Setup Screen
Table 3.3.1. Menu Items in Recording Mode Setup
Menu Item
Description
CHANNEL
Select a channel for applying the following settings using the mouse or the
control button on the remote control. Press the right square button to change
the setting value of all channels at once. Once you the value has been changed,
select OK to confirm the changes.
(RESOLUTION, FRAME RATE, QUALITY, RECORDING, PRE RECORD and POST
EVENT RECORD)
RESOLUTION
 Analog DVR (N-0440MH, N-0840MH, N-1640MH): Select either CIF, Half D1 and
D1 using the mouse or the control button on the remote control.
 HD-SDI DVR (HD-0405M, HD-0810M): Select either 640 x 360, 1280 x 720, 1920
x 1080 using the mouse or the control button on the remote control.
FRAME RATE
Set the frame rate for the specified channel. The sum of the frame rate values
from each channel cannot exceed the maximum frame rates for a specific
recording resolution.
Typical values of the maximum frame rate for video are as follows.