User`s guide

109 | P a g e
APPENDIX: How to Connect the Network
A. How to set the IP address of the DVR and open TCP port of the router?
The port forwarding steps will vary depending on the brand and model of the router. Port Forwarding is required to
access the DVR remotely. (NOTE: Please check your router’s User’s Manual for detailed instructions on Port
Forwarding)
Connect network cable between DVR and Router or ADSL modem.
1. Default network setting on DVR are
- Port: 5445
- WEB Port : 80
- Network : DHCP
2. From a PC connected to the same Router as the DVR, select start>run>cmd to open the command prompt.
In the command prompt, type “ipconfig” to find the following information; IP Address, Subnet Mask, and
Default Gateway.