User`s guide

DVDO Matrix
6
6x2 4K Ultra HD HDMI Matrix Switcher
DVDO Matrix
6
5 A.04
Input/Output
Front Panel
1. IR window – remote control receiver
2. Input indicators (Off = no connection, Amber = HDMI connected, Green = active Zone 1 input, Yellow =
active Zone 2 input)
3. Input select – manually cycles through connected Zone 1 inputs
4. Power switch
5. Power indicator
Back Panel
1. Power input – 12 VDC 3 A minimum
2. Update firmware button – see the firmware update section for details. This button is held during power-up
to start the firmware update process from an attached USB flash drive.
3. USB connector – Primarily used for updating firmware, but also supplies 5 V up to 1 A for accessories
4. Serial port: allows control of Matrix
6
by external control systems
5. HDMI outputs – The two outputs are independent and can be individually controlled.
6. S/PDIF audio outputs – Coax and optical: Whenever the audio stream permits, audio is extracted from
the active Zone 1 input and also sent to the S/PDIF outputs
7. HDMI Inputs 1–6 – Input 1 and Input 6 are each capable of connecting to a MHL mobile device as well
using only a passive cable. These ports can each supply up to 900 mA for charging the mobile device.