User`s guide

DVDO Matrix
6
6x2 4K Ultra HD HDMI Matrix Switcher
DVDO Matrix
6
22 A.04
resetting to defaults,
Defaults not saved
properly
2. Press ENTER again to confirm and start the reset
3. Wait 30 seconds
4. Power Matrix
6
down and then back up
Audio Return
Channel not working
Audio Return channel depends on a set of instructions passed between the primary
display and Matrix
6
. Since Matrix
6
replaces the AVR as the main switching device in
the system, Matrix
6
has the ability to appear as both a standard switcher and/or an
AVR to the display. First, set up the TV to allow ARC, and then Matrix
6
can be
Matrixly set to “appear as a switcher” (turning off the ARC channel) or “appear as an
AVR” (turning on the ARC channel).
1. In the primary TV menu system, turn CEC on. (Note that different
manufacturers use different brand names for this function – refer to the TV
user’s manual for more information on enabling commands over HDMI)
2. In the primary TV menu system, enable ARC (usually in an audio menu)
3. If applicable to your TV, scan for and select Matrix
6
as the primary audio
source
4. Use Matrix
6
to enable and disable ARC channel as needed with one of the
following methods:
a. From the Advanced Setup menu in Matrix
6
choose “Initiate ARC” to
start the channel or “Terminate ARC” to stop the ARC channel. These
commands are provided separately in case your TV needs to see the
command more than one time to make the switch.
b. From the Matrix
6
remote control, press the ARC button one time to
enable ARC channel and again to disable ARC channel.
The path for ARC is from the main display “into” the Main Matrix
6
HDMI output then
out of the S/PDIF output on Matrix
6
. So when you press the ARC button on Matrix
6
remote control, the S/PDIF output will switch back and forth between the audio from