Product manual

Section 5: Updating Firmware
95
Note about Firmware Updates and User Preferences
A firmware update initially resets EDGE GREEN to its factory default state, however, your EDGE GREEN includes a special data
structure for storing user preferences. This was added to eliminate the need to restore factory defaults following firmware updates.
This in turn eliminates erasing user preferences when firmware is updated in the future.
The new data structure is built in EDGE GREEN’s memory immediately after copying the firmware to EDGE and unplugging the USB
cable. During the time it takes to build the data structure, EDGE’s front LED will flash red/green.
After the new firmware is copied to EDGE and the USB cable is disconnected, the front LED will flash red/green for 2-4
minutes. This is normal for this firmware. Just wait for it to stop flashing.
Connect EDGE to your computer
The smaller connector on the Mini-USB cable will connect on the back of EDGE. Next to the Mini-USB connector, there is a little hole;
the RESET button is inside that hole. The Reset Button and the Mini-USB connector are shown in the photo below.
Mini-USB Connector
Reset Button