Product manual

Section 1: Introduction
19
Rear Panel: Audio & Video Outputs
HDMI 1.3 Video/Audio
This connector is used to carry video to your TV or display. It will also carry audio depending on how you configure your
EDGE GREEN.
HDMI 1.3 Audio Only
This connector is intended to connect to an AV Receiver for audio processing. EDGE GREEN will automatically send audio to
this connector if it is connected to a powered-up AV Receiver, or you can manually configure EDGE GREEN’s audio output.
This connector does not output video.
Optical
If you have an AV Receiver for audio processing, but it does not have an HDMI input, you can use the Optical output to
connect audio from your EDGE GREEN to your AV Receiver.
Configuration of the audio output of EDGE GREEN can be done using the Settings Menu.
Other Rear Panel Connectors
Service
This connector is used for software upgrades if they are necessary using a mini-USB cable. Refer to the web site:
www.simplaylabs.com for updates regarding software upgrades.
Reset
Resets the EDGE GREEN, and brings it into a known state. Reset does not change user settings. If Reset is used, it should
be pressed and released quickly (less than 2 seconds).
The reset button will also restore factory defaults. If the reset button is pressed and held, the front panel LED will blink for
about 5 seconds. When it stops blinking and stays on, the reset button can be released. All factory defaults will have been
restored, and any user settings will be erased.
IR - In
This connecter can be used in installations where line-of-sight IR reception is not possible in conjunction with accessories
that allow for remote IR connections.
AC Input
Power connection for your EDGE GREEN.